Kenmore Pro 72583 Manuel du propriétaire télécharger pdf (Page 36)

Care and Cleaning

Cleaning Surface Burner Heads

For proper gas flow it may be necessary to clean the burner

head and slots. To clean, first use a clean DAMP cloth to soak up

any spills. Remove any food from between the burner slots using

a small nonabrasive brush like a toothbrush and afterwards

wipe up using a damp cloth. For stubborn soils located in the

slots, use a small-gauge wire or needle to clean.

Any spill on or around the electrode must be carefully cleaned.

Take care not to hit the electrode with any thing hard or it could

be damaged.

Important note:

Small food particulars on or around the electrode could stop the

burner from lighting.

To clean the burner head ignition ports

Each burner head has a small ignition port located as shown.

Should you experience ignition problems it may be that this port

hole is partially blocked with soil. With the burner head in

place, use a small wire gauge needle or the end of a paper clip

to clear the ignition port (Figure 41; round style shown; oval

burner on some models not shown).

Important notes:

• The surface burner heads are secured to the cooktop and

must be cleaned in place on the cooktop.

• Always keep the surface burner caps in place whenever a

surface burner is in use.

• When replacing the burner caps, be sure the burner caps

are seated firmly on top of the burner heads. Improper

flame size and uneven heating may result when any surface

burners are turned on and the burner caps are not seated

correctly.

• For proper flow of gas and ignition of burners do not allow

spills, food, cleaning agents or any other material to enter

the gas orifice port opening.

Replacing the Oven Light

The round halogen oven light is located at the rear of the oven

cavity and is covered with a glass shield held by a wire holder

(Figure 42). The glass shield protects the light bulb and must be

in place whenever the oven is in use.

To replace the oven interior light bulb:

Be sure the range is unplugged and all parts

are cool before replacing oven light. Wear a leather-faced

glove for protection against possible broken glass.

1. Turn electrical power off at the main source.

2. Remove interior oven light shield by turning a quarter turn

counter-clockwise (Figure 43).

3. Replace bulb with a new T-4 type Halogen 25 watt

appliance bulb.

Important: Do not allow your fingers to touch the new bulb when

replacing. This will shorten the life of the bulb. Use a paper

towel or cotton glove while handling the new bulb when

installing.

4. Replace glass oven light shield by rotating clockwise. The

glass shield must be in place whenever the oven is in use.

5. Turn power back on again at the main source (or plug the

appliance back in).

6. The clock will then need to be reset. To reset, see “Setting

The Clock” on page 18.

Figure 41: Cooktop burner head

slots

ignition port

orice port

Figure 42: Oven Halogen light

Figure 43: Replacing the oven Halogen light

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Kenmore Pro 72583 Manuel du propriétaire Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Kenmore Pro 72583