Kenmore Pro 72583 Guide d'installation télécharger pdf (Page 6)

30" GAS RANGE INSTALLATION INSTRUCTIONS

2.2

Provide an adequate Gas Supply

When shipped from the factory, this unit is designed

to operate on 4" (10,16 cm) water column (1,0 kPa)

Natural gas manifold pressure. A convertible pressure

regulator is connected to the range manifold and

MUST be connected in series with the gas supply line.

If LP/Propane conversion kit has been used, follow

instructions provided with the kit for converting the

pressure regulator to LP/Propane use.

Care must be taken during installation of range not to

obstruct the ﬂ ow of combustion and ventilation air.

For proper operation, the maximum inlet pressure to

the regulator should be no more than 14" (35,56 cm)

of water column pressure (3,5 kPa). The inlet pressure

to the regulator must be at least 1" (0,25 kPa) greater

than the regulator manifold pressure setting. Examples:

If regulator is set for natural gas 4" (10,16 cm) manifold

pressure, inlet pressure must be at least 5" (12,60 cm);

if regulator has been converted for LP/Propane gas 10"

(25,4 cm) manifold pressure, inlet pressure must be at

least 11" (27,9 cm).

Leak testing of the appliance shall be conducted

according to the instructions in step 4H.

The gas supply line should be ½" or ¾" I.D.

Seal the openings

Seal any openings in the ﬂ oor under the range after

gas supply line is installed.

2.1

Gas and Electric Entry Preparation

• The hatched areas are the locations where the gas

line can enter the cabinet (ﬁ gure 5a).

• The recommended position for the gas entry line is

located at 7" (17,8 cm) from the left cabinet wall and

2" (5,1 cm) from the ﬂ oor (ﬁ gure 5a).

• The shaded area is the location where the electric

outlet can be located (ﬁ gure 5a).

• If you are using a through the ﬂ oor gas entry,

remove the line protector shield from the bottom of

the unit to allow access for the pipe line (ﬁ gure 5b).

• We recommend to install a pipe elbow right out of

the ﬂ oor or wall towards the center of the unit to

ease the installation.

4.5

7½

2½

WALL

2½

(76.2)

(5.1)

(30.5)

Recommended

position

Note: All dimensions are in inches (centimeter).

Figure 5a

To remove the line protector, remove the 3 screws.

Figure 5b

Gas pressure regulator location

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Kenmore Pro 72583 Guide d'installation Page 6

Commentaires sur ces manuels